Posted: November 24th, 2022

8918

In this exercise, you’ll apply section styles to differentiate between sections that represent finished ground, existing ground, and rock surfaces.
In this exercise, you’ll apply section styles to differentiate between sections that represent finished ground, existing ground, and rock surfaces.
In this exercise, you’ll apply section styles to differentiate between sections that represent finished ground, existing ground, and rock surfaces.

1. Open the drawing named Applying Section Styles.dwg located in the Chapter 11 class data folder.

Here, you see three section views that were plotted to investigate the shallow rock layer. The section views show a corridor section, existing ground surface section, and rock section.

2. Click the lowest section in the 8+50.00 (0+260.00) section view, and then click Section Properties on the Section: Rock ribbon tab.

3. On the Information tab of the Section Properties dialog box, change Object Style to Rock. Click OK to close the dialog box. Press Esc to clear the selection.

The rock section now appears as a gray dashed line.

4. Repeat the previous two steps for the section that appears above the rock layer, this time assigning a style of Existing Ground.

The section representing existing ground now appears as a red dashed line along with the rock section from the previous step (see Figure 11.1).

5. Click the lower section in the 9+00.00 (0+270.00) section view, right-click, and select Properties.

6. In the Properties window, change Style to Rock. Keep the Properties window open.

7. Press Esc to clear the selection of the rock section. Click the existing ground section, and use the Properties window to change its style to Existing Ground.

8. Press Esc to clear the previous selection, and then click one of the grid lines for the 9+25.00 (0+280.00) section view. Click Section View Properties on the ribbon.

9. On the Sections tab of the Section View Properties dialog box, in the Style column, change the style of the section named EG to Existing Ground, and for the section named Rock, change the style to Rock. Click OK to dismiss the Section View Properties dialog box. Press Esc to clear the selection.

All three section views should now properly display the existing ground and rock sections.

10. Save and close the drawing.

You can view the results of successfully completing this exercise by opening Applying Section Styles – Complete.dwg.

—–

You’ll use section styles to distinguish between sections that represent finished ground, existing ground, and rock surfaces in this activity.

You’ll use section styles to distinguish between sections that represent finished ground, existing ground, and rock surfaces in this activity.
You’ll use section styles to distinguish between sections that represent finished ground, existing ground, and rock surfaces in this activity.

1. Open the Applying Section Styles.dwg drawing from the Chapter 11 class data folder.

Three section views were plotted to study the shallow rock layer, as seen here. A corridor portion, current ground surface section, and rock section are shown in the section views.

2. In the 8+50.00 (0+260.00) section view, pick the lowest section, then click Section Properties on the Section: Rock

Order | Check Discount

Tags: APN nursing help, assignment help online free help with assignment online, assignment help website, best website for nursing assignment, college homework help websites, DNP nursing help